Novice Tips: Firmware Upgrades Robo 3D R1

 
Published on May 23, 2015
Channel: Novice Expert
Category: People & Blogs
Source: Youtube

Tuning firmware is not necessary, but required for increased performance. Skip around with the timestamps below **** Click [Show More] for links **** Time Stamps: 1:00 For Z motor Enable 1:34 For Z steps/mm 2:08 For Faster Bed Leveling 4:08 For Quieter Motors 5:38 For Setting Up Dual Extrusion Important Links: Robo 3D Firmware: http://guide.robo3d.com/Wiki/ROBO_3D_Firmware_Release_Notes Arduino Software: http://bit.ly/1LvxnkL Social Links: Vlog Channel: https://www.youtube.com/channel/UCxBGHv4FWLsKVNLq9JscZuA Instructables: http://www.instructables.com/member/LVMJohnson1996/ Thingiverse: http://www.thingiverse.com/MarquisJohnson/about Facebook: https://www.facebook.com/NoviceExpert Twitter: https://twitter.com/YT_NoviceExpert